| Author
|
Traktor 3 - unable to route a headphone cue mix in EMU 1616
|
Pypedream
IsraTrance Junior Member
Started Topics :
45
Posts :
245
Posted : Dec 20, 2006 21:12
|
Anyone using Traktor 3 successfully with a main mix and a headphone cue mix?
In EMU patch mix sofware, I figure there needs to be two separate ASIO channels, one for main out and one for booth or monitor. However I can't get the cue mix thorugh the EMU dock's headphone output. Tried all sorts of virtual send combos and can't get it. Next stop: EMU tech support.
I am trying to set up a configuration whereby I have the main mix output on one strip, and another "cue" mix playing through headphones. I have the software's routing set up as follows: Main mix output routed to Patchmix ASIO 1/2 channel strip. Booth (monitor) output routed to Patchmix ASIO 3/4 channel strip. I now want to hear the ASIO 3/4 channel strip through the dock headphones only. What type of virtual or aux send do i need to set up?
  ELECTRON EYES / MARK-EVAN (NOR. CAL)
WWW.SOUNDCLOUD.COM/MARK-EVAN |
|
|
|
Jeto
Jeto
Started Topics :
258
Posts :
3252
Posted : Dec 20, 2006 23:55
|
Hello,
Im not sure with the EMU, but I use it succesfully with NI KORE and it works a charm.
It seems like your card has 2 Stereo Outputs, so its possible. Might have to play with the settings till you get it or call thier tech support.
https://www.djjeto.com |
|
|
|
BonzaiBee
Started Topics :
1
Posts :
10
Posted : Jan 11, 2007 02:01
|
hi, you might want to check out the 'unofficial emu-forum' (google for link)
also the headphone out is just a copy of the main out, no separation of signal. What you could do if this is the problem is using a splitter to attach your headphone directly to the 3 and 4 out, one that goes from 2 jacks to 1 cinch so you can put your headphone in the cinch
|
|
|
|
serotonot
Started Topics :
7
Posts :
114
Posted : Jan 18, 2007 15:29
|
Hi!
You need to make 2 mixer channels in the patch mix software for asio outputs.
Put for example asio 3/4 to master output in Traktor. Then in patch mix send the asio 3/4 channel strip to physical output 2.
Then set asio 1/2 to cue output in traktor. Then in patch mix send the asio 1/2 strip to physical output 1.
Then of course you have to plug your output cables to emu's output 2.
I had to sell my pcmcia 1616 recently but I remember that I had to play around with the output routing for a while before making it work.
I'm not 100% sure I remember thaa config correctly but it was at least close to the one I mentioned above.
And remember that headphones come out always from output 1 in Microdock.
Hope this helped  |
|
|
|
