| Author
|
Position the automation points exactly in the center.
|
YANTRA
IsraTrance Full Member
Started Topics :
66
Posts :
166
Posted : Jul 19, 2007 19:20
|
|
Good afternoon! Does anyone can tell me what should i do to move an automation curve point to the centr.. cubase playlist automation lines...no matter how i try it just goes very near, like left 6.. but dont reac the center.. i tried tur snap of, quantize etc but does not work, is there any key combination to fine tune this? tried a few default but no success.. thanks, u guys rock! |
|
|
Alex - Aural Invasion
Aural Invasion
Started Topics :
37
Posts :
514
Posted : Jul 19, 2007 20:27
|
if you zoom in, then it should be very easy. just drag in the track 
 myspace.com/auralinvasion
reverbnation.com/auralinvasion
www.aural-invasion.com |
|
|
|
parapsyched
Scratch 22
Started Topics :
72
Posts :
548
Posted : Jul 19, 2007 23:45
|
just click on the point and change its value in the info line.......
if u dig deep enough u just might reach the sky...
"dream is destiny"
http://www.scratch-22.com |
|
|
|
YANTRA
IsraTrance Full Member
Started Topics :
66
Posts :
166
Posted : Jul 20, 2007 16:35
|
No matter how much zoom has on it, the zoom do not hv the accurace for this situation, it keeps the same.
As changing values in infoline, it works but how do u potition it the pan value to the center? Thre are tree variables which are type (pan left right ,in this case), star and value. I only can make changes for "start", but the value is the one that shows up the setting i need to change. I even can see the value changing in the infoline when i drag it with the mouse , but it is unabled to be changed by there.. by the way the tree variables start,type and value are showed in the infolan tab... the point is i cant change it there!!!
thank you! |
|
|
|
ThiagoNAKA
IsraTrance Full Member
Started Topics :
104
Posts :
1047
Posted : Jul 20, 2007 18:24
|
This is how I do:
1) Take a channell and be sure the PAN is at "C"(center).
2)Press "R"(read) at the channell, and go to automation line for the PAN. U should see a straight blue line(as u didnĀ“t make any automation yet).
3)Make a point at this blue line(better using "bar" quantize). Now just select the point, and COPY it "ctrl+c).
4)Now all u need to do is to choose the chanell that u want to put a middle point, choose the position, and press ctrl+v. Middle point will be there!
Sounds really annoying.... Does anybody has better workflow for this situation??? Colin???
LOADING... |
|
|
|
xoC
Cubic Spline
Started Topics :
10
Posts :
179
Posted : Jul 20, 2007 20:14
|
yep, select the right channel, ctrl+b for project explorator, and ... edit the value  |
|
|
|
