| Author
|
New Linplug VSTi - MorphoX
|
Get-a-fix
Getafix
Started Topics :
147
Posts :
1441
Posted : Oct 15, 2010 18:20:57
|
|
Nectarios
Martian Arts
Started Topics :
187
Posts :
5292
Posted : Oct 15, 2010 18:41
|
|
Upavas
Upavas
Started Topics :
150
Posts :
3315
Posted : Oct 16, 2010 11:06
|
|
kajola
Kajola
Started Topics :
74
Posts :
498
Posted : Oct 16, 2010 11:49
|
|
Get-a-fix
Getafix
Started Topics :
147
Posts :
1441
Posted : Oct 16, 2010 18:02
|
|
Djones
IsraTrance Senior Member
Started Topics :
267
Posts :
1766
Posted : Oct 16, 2010 19:12
|
|
Sounds very convincing! |
|
|
APriest
Started Topics :
2
Posts :
98
Posted : Oct 16, 2010 19:55
|
|
In albino (and in Blue if i remember correctly) you can't set the phase of oscillators, great issue to mix waveforms.... finally this new synth seems to have the phase knob. |
|
|
|
Obelizk
Amoeba
Started Topics :
115
Posts :
836
Posted : Oct 18, 2010 13:46
|
|
PsiloCybian
Mammal Footwork
Started Topics :
92
Posts :
557
Posted : Oct 25, 2010 09:51
|
|
Nectarios
Martian Arts
Started Topics :
187
Posts :
5292
Posted : Oct 25, 2010 11:15
|
Quote:
|
On 2010-10-16 19:55, APriest wrote:
In albino (and in Blue if i remember correctly) you can't set the phase of oscillators, great issue to mix waveforms.... finally this new synth seems to have the phase knob.
|
|
You can't? I could have sworn you can always start from the same phase on Albino's oscillators. I've made a bassline for a tune using albino, all played in real time and the notes where exactly the same, as if they were sampled.
http://soundcloud.com/martianarts |
|
|
|
PsiloCybian
Mammal Footwork
Started Topics :
92
Posts :
557
Posted : Oct 25, 2010 11:38
|
|
APriest
Started Topics :
2
Posts :
98
Posted : Oct 26, 2010 08:37
|
Oh my god, there isn't a display for parameter values!
Damned Linplug, after the phase knob give us a display. |
|
|
|
Nectarios
Martian Arts
Started Topics :
187
Posts :
5292
Posted : Oct 26, 2010 17:47
|
Quote:
|
On 2010-10-26 08:37, APriest wrote:
Oh my god, there isn't a display for parameter values!
Damned Linplug, after the phase knob give us a display.
|
|
You can see the values when you select to view the corresponding parameter in the channel automation view. Still a bit shite tho as the resolution of steps in the lower end of the cut-off frequency in Albino, was very poor...nothing a few takes of "touch" mode can't sort out tho...anyhow hope they sort this with Morphox.
Peace.
http://soundcloud.com/martianarts |
|
|
|
ansolas
IsraTrance Full Member
Started Topics :
108
Posts :
977
Posted : Oct 28, 2010 18:43
|
|
