| Author
|
Massive Osc: Free run?
|
martyn
IsraTrance Junior Member
Started Topics :
40
Posts :
389
Posted : Jun 16, 2008 21:55:48
|
Hi,
i have a question regarding NI Massive:
I built a simple Saw-Bassline from scratch (with env1 on Filter 1). There occur irregular subtle cracks in the attack phase. It sounds like the Osc was free-running.
I played around alot with the envs, checked if any modulation was used - but nothing helped.
Is there a solution like "syncing" the oscs (in the sense of always starting in the exact same position everytime they are triggered)? AFAIK the oscs are based on wavetable so they probably don't free-run at all but it sounds like they did.
What else could cause this problem?
Any help recommended!
Regards - martyn
  www.myspace.com/mentris |
|
|
|
Speakafreaka
IsraTrance Junior Member
Started Topics :
18
Posts :
779
Posted : Jun 17, 2008 02:37
|
yup,
click on the 'OSC' tab (where you control glide rate)
then make sure the 'Restart via Gate' checkbox is highlighted.
Bingo.
When it isn't highlighted, the oscs simply churn away from whatever point they started at and the Midi On/Off signals simply trigger the envelope to either start or go into the release cycle.
I wouldn't pay too much attention to the wavetable gubbins. Nearly every single VST out there is a wavetable synth, although Massive has some nice Osc tricks; each osc is in reality just an array of Oscs (which is still very cool  ).
.
http://www.soundcloud.com/speakafreaka |
|
|
|
martyn
IsraTrance Junior Member
Started Topics :
40
Posts :
389
Posted : Jun 17, 2008 12:19
|
|
Speakafreaka
IsraTrance Junior Member
Started Topics :
18
Posts :
779
Posted : Jun 18, 2008 04:36
|
|
