| Author
|
Inside modulation matrix (question)
|
YANTRA
IsraTrance Full Member
Started Topics :
66
Posts :
166
Posted : Mar 23, 2008 15:30:37
|
Hey guys! Hope it's all good!
I wonder if any of u could explain to me if is there any way of doing a "source" -> "target" that would make the cut of button of the filter goes up and down in a range of frequencies thas was set. This would be instead of automation. I am not very good on understanding modulation matrix processes , so i wish u give me a light.
In z3ta is it possible to do that? (or any specific synth?)
  www.myspace.com/beehivelive |
|
|
|
Suloo
IsraTrance Full Member
Started Topics :
87
Posts :
2822
Posted : Mar 23, 2008 15:35
|
Lfo as source and filter frequency(cutoff) as target..then find your suitable amount and settings for the lfo..pretty simple!
good luck!
-------......-------...-..-..-..-.-.-.-.- |
|
|
|
Suloo
IsraTrance Full Member
Started Topics :
87
Posts :
2822
Posted : Mar 23, 2008 15:36
|
sorry..double post
-------......-------...-..-..-..-.-.-.-.- |
|
|
|
pilgrim
IsraTrance Junior Member
Started Topics :
19
Posts :
218
Posted : Mar 23, 2008 15:36
|
I think you're looking for LFO - they bring movement to the sound in a certain rate and in a certain waveform....
look google, wikipedia, read about signal flow of synths, try and have fun
|
|
|
|
anigbrowl
Started Topics :
2
Posts :
26
Posted : Mar 24, 2008 00:16
|
Yeah, set up a modulation like LFO - filter cutoff and just use a small amount, like 5%.
Play some notes so you can hear the effect. Move the filter cutoff around until it is in about the right area, then adjust the modulation amount from 5% to get the amount of variation you like. |
|
|
|
