| Author
|
How to connect hardware synth to cubase
|
Nabla jpr
IsraTrance Junior Member
Started Topics :
17
Posts :
130
Posted : Jun 22, 2008 11:06:52
|
Hi folks!
I got my first synth which is a creamware Pro-12 asb, but I can't connect it to cubase. I mean I connected it through usb, and the audio output to the audio input of my sound card but I can't hear anything in cubase(I see signal coming in the channel but not in master channel). Do I need to tell cubase that is receiving and input from outside?I did check the device panel though...if I connect it to the mixer no problem..it sounds amazing..
any ideas?
cheers
Nab |
|
|
bilbobagginz
Started Topics :
8
Posts :
399
Posted : Jun 22, 2008 16:08
|
make sure the impedances of your audio interface match the synths output, and make sure you didn't screw up the routing matrix of your soundcard's mixer.
(this is usually the case - muted channels or bad routing )
|
|
|
|
Glitch_CapeTown
IsraTrance Junior Member
Started Topics :
36
Posts :
952
Posted : Jun 22, 2008 22:45
|
|
Nabla jpr
IsraTrance Junior Member
Started Topics :
17
Posts :
130
Posted : Jun 23, 2008 14:41
|
ibeen sorted..cheers guys
nab |
|
|
|
Nabla jpr
IsraTrance Junior Member
Started Topics :
17
Posts :
130
Posted : Jun 24, 2008 10:14
|
got another problem....the signal coming in is too low..is this mean that the impedance of the synth is different from the one of the audio in of my sound card?
|
|
|
|
Nabla jpr
IsraTrance Junior Member
Started Topics :
17
Posts :
130
Posted : Jun 30, 2008 11:13
|
still have the same problem...the signal is too low..I checked my soundcard it seems everything's ok..
any advice?
cheers
Nabj |
|
|
|
UnderTow
Started Topics :
9
Posts :
1448
Posted : Jun 30, 2008 19:28
|
What is too low? If you are recording at 24 bits (highly recommended) you can safely record quite low.
UnderTow |
|
|
|
Nabla jpr
IsraTrance Junior Member
Started Topics :
17
Posts :
130
Posted : Jul 1, 2008 10:16
|
Undertow,
I don't know wheter this is normal but the signal going from my synth to the input of my soudcard sounds too low(sometimes it doesn't reach -20,-15dbFs)
I thought it was an impedance problem, it could have been that the cable was balanced(it has a greater impedance) but I am using unbalanced cables
you mean recording the synth at 24 bit?because my sound card convetrs it at 24bit?
cheers
Nab j |
|
|
|
acidkills
IsraTrance Junior Member
Started Topics :
26
Posts :
431
Posted : Jul 1, 2008 14:55
|
|
