| Author
|
how can i draw automation lines of hardware synth in SX??
|
diskOtek
Entek
Started Topics :
70
Posts :
953
Posted : Aug 7, 2007 18:02
|
hello!
topic says it-is there a way to draw lines for automation instead of recording them in real time tweaking??
(i have the bass station synth and wanna draw in sx2)
greetz!!
|
|
|
orange
Fat Data
Started Topics :
154
Posts :
3918
Posted : Aug 7, 2007 22:39
|
u have to know wich midi cc is each parameter in ur basstation as far i remember cutoff is 105 and resonance 106 i think its the same for every novaton synth..
in cubase in the piano roll area down where u tweak the velocity etc.. to the left ther is a small drop down menu where u can change the parameter or cc number parameter!
full list of all the CC assignments for the Bass Station: 1 - Mod wheel 2 - Breath 5 - Portamento 7 - Master volume 12 - Osc sync 13 - LFO waveform 14 - Osc 1 waveform 15 - Osc 2 waveform 16 - LFO speed 17 - LFO delay 18 - LFO sync rate 20 - Osc 1 env mod depth 21 - Osc 1 LFO mod depth 22 - Osc 1 PWM depth 23 - Osc 2 semitone tune 24 - Osc 2 fine tune 25 - Osc 2 LFO mod depth 26 - Osc 2 env mod depth 27 - Osc 2 PWM depth 28 - Osc 1/2 mix 34 - Osc voice mode 35 - Filter LFO mod depth 40 - Filter slope 41 - Osc 2 Octave 64 - Sustain pedal 105 - Filter cutoff 106 - Filter resonance 107 - Filter env mod depth 108 - Amp env attack 109 - Amp env decay 110 - Amp env sustain 111 - Amp env release 112 - Amp env velocity mod 114 - Mod env attack 115 - Mod env decay
be sure to have connected ur bassstation midi in and out..!
orange
 http://www.landmark-recordings.com/
http://soundcloud.com/kymamusic |
|
|
|
diskOtek
Entek
Started Topics :
70
Posts :
953
Posted : Aug 8, 2007 11:27
|
thanks for the help akis!
be well!
|
|
|
|
Colin OOOD
Moderator
Started Topics :
95
Posts :
5380
Posted : Aug 8, 2007 20:01
|
|
